|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
Paper Quantity Switch Assembly
1 2 Remove the Back Cover from the 2000-sheet Input Tray (see figure 6-65 on page 238). Locate the cable that runs from the Paper Quantity Switch Assembly on the 2000-sheet Input Tray to the unit�s Controller PCA. Disconnect the cable from the Controller PCA (J205 connector), and then free the cable from the cable clips that secure it to the chassis (Figure 6-76, callout 1). Remove the 1 screw (callout 2) and the metal retaining spring (callout 3) that hold the switch assembly in place. Pull the switch assembly out of its cavity (Figure 6-77, callout 1).
3 4
To Reinstall:
1 When reinstalling the metal retaining spring that holds the switch assembly in place (Figure 6-76, callout 2), seat the retaining spring onto the locating pins that are on the chassis. Reconnect the switch assembly�s cable to the J205 connector on the Controller PCA (Figure 6-76, callout 1).
2
Paper Size Switch Assembly
1 2 Remove the Back Cover from the 2000-sheet Input Tray (see Figure 6-65). Locate the cable that runs from the Paper Size Switch Assembly on the 2000-sheet Input Tray to the unit�s Controller PCA. Disconnect the cable from the Controller PCA (J204 connector) (Figure 6-76, callout 4). Remove the 1 screw (callout 5) and the metal retaining spring (callout 6) that hold the switch assembly in place. Pull the switch assembly out of its cavity (Figure 6-77, callout 2).
3 4
To Reinstall:
1 When reinstalling the metal retaining spring that holds the switch assembly in place (Figure 6-76, callout 5), seat the retaining spring onto the locating pins on the chassis. Reconnect the switch assembly�s cable to the J204 connector on the Controller PCA (Figure 6-76, callout 4).
2
C4214-91000
2000-sheet Input Tray Removal and Replacement 257
|
|
|
> |
|
